=====================================================================
=              Firmware for GPIB Communication                      =
=                                              CUFGPIB.bin Ver1.17  =
=                                                  CONTEC Co.,Ltd.  =
=====================================================================

- Contents
===========
  Introduction
  Firmware file
  Supported module
  Career at version up


- Introduction
==============
  Here, the firmware of GPIB communication is explained.


- Firmware file
===============
  A firmware file is binary form, and is downloaded and used for a USB module.
  The newest firmware file is stored in API-USBP(WDM).
  If the firmware of USB module is the old version, please update the firmware with update tool.


- Supported module
==================
  The modules which can be used with this firmware is shown below.
      GP-IB(USB)FL


- Career at version up
======================
  Ver1.16->Ver1.17 (2011.12.09)
  ----------------------------------------
  - A device corrects the fault which may repeat a new recognition. 

  Ver1.15->Ver1.16 (API-USBP(WDM) Ver4.10)
  ----------------------------------------
  - Fault correction that received exceeding number of upper bound data that 
    can be set reception it when receiving it in the USB_FIFO mode.
  - Fault correction that extra data is inserted in receive data when receiving it in the USB_FIFO mode.

  Ver1.13->Ver1.15 (2009.05.20)
  ----------------------------------------
  - Fault correction that is not stand the END bit when only EOS is received by using API-GPLV(W32) in the FIFO mode. 
  
  Ver1.12->Ver1.13 (2008.03.18)
  ----------------------------------------
  - Fault  correction where timeout is generated when sending and receiving continuousness operates.

  Ver1.11->Ver1.12 (API-USBP(WDM) Ver3.70)
  ----------------------------------------
  - Fault  correction that cannot be sent and received by API-GPLV(W32) driver in "USB_INT"mode.

  Ver1.09->Ver1.11
  ----------------------------------------
  - It corresponds to the transfer mode on property page selection change.
  - Fault correction of control of LED of LINK.

  Ver1.07->Ver1.09
  ----------------------------------------
  - Fault correction when continuousness received..
  - Fault correction that receives extra data when received.

  Ver1.04->Ver1.07 (API-USBP(WDM) Ver3.50)
  ----------------------------------------
  - Fault correction that cannot be received when one byte without delimiter is received.
  - Adaptation to standard of EMC Directive.

  Ver1.03->Ver1.04 (Web 2006.08.10)
  ----------------------------------------
  - Fault correction that timeout is generated at time that is shorter than timeout setting value.

  Ver1.03 (API-USBP(WDM) Ver3.20)
  ----------------------------------------
  - Support API-GPIB(98/PC) and API-GPLV(W32)
  - Fault correction that cancel of serial poll can't move after data receive.
  
  Ver1.00 (API-USBP(WDM) Ver3.10)
  ----------------------------------------
  - Release.